Saturday, November 20, 2010

A suburu legacy the whole power steering pump is changed how do i bleed the air out?

its kind of hard to turn than before i changed it.A suburu legacy the whole power steering pump is changed how do i bleed the air out?
Most vehicles will self bleed by filling the power steering reservoir and starting the vehicle. Turn the wheel in both directions several times. Shut off and refill the reservoir. Start the car again and repeat the process.A suburu legacy the whole power steering pump is changed how do i bleed the air out?
jack up the front end and turn the steerong wheel all the ways both ways until it stops whiningA suburu legacy the whole power steering pump is changed how do i bleed the air out?
before you start the engine crank the wheel lock to lock 2-3 times before starting the engine to bleed the air out. then start the engine %26amp; do the same. if you still have noise from the pump then restart the procedure over %26amp; try again. remember to keep checking the fluid level though, it will lower as the air bleeds out.A suburu legacy the whole power steering pump is changed how do i bleed the air out?
You can follow the instructions of the other posters, and it should work. You can also turn the wheel to the limits on both ends. Bump the wheel back and forth against the limits until the whine stops. You HAVE to do this while the car is running. It is the only way to properly bleed the rack.
  • reptiles
  • blocked myspace
  •