to change the power steering pump in my 88 s-10. there is a massive leak. were else could the problem be?How hard is it?
One of the hoses may have cracked/split/burst, the sector shaft seal may be leaking (it's the one in the bottom of the steering gearbox). That's about all there is in a power steering system. Make sure the pump is the problem. On most vehicles, the pump isn't hard to remove, it's the pully that is a bear to change. A special tool is usually required. Parts house may rent them.How hard is it?
Pump or lines to it could be leaking. If you can change a water pump you can change this, but first you must locate the leak.How hard is it?
Hoses -
Check all the hoses - wash off the engine bay, run it and have a friend turn the wheel slow so you can see where it is leaking from.
Hoses are a lot easier to swap out.
But if it is the pump it should not be that bad of a task.How hard is it?
not to hard...get the shop manual from advance or other ....best 15 dollars u can spend........that being said most leaks are bad hoses...very high pressure....[ i did have a PS pump reservoir crack in my 1984 s 10]How hard is it?
Not sure how hard it would be, but you can check all your lines. If you have a section of rubber tubing then your best bet is to replace it and put two hose clamps on each end if it is a return line. If it's a high pressure line you probably have to buy a line that is fitted for it.How hard is it?
It's not that difficult, assuming you have some automotive, or mechanical aptitude! If you've never worked on the truck before, go get a Chilton's, (thats what the main book was called when I did my own work), or other repair manual and follow directions!How hard is it?
could be pump, lines or gear box.
